Blow molding machine manufacturers briefly describe the maintenance methods of blow molding machines

Blow molding machine manufacturers briefly describe the maintenance methods of blow molding machines

　　If you want the bottle blowing machine to last longer, the maintenance and maintenance of the bottle blowing machine is essential. The following bottle blowing machine manufacturers will introduce us how to maintain and maintain the bottle blowing machine.

1. Feeding level without feeding: several conditions need to be checked: whether the hopper of the blow molding machine is out of feed, the assumption is: the need to feed at a fast speed is not: please check whether the control contactor of the forward machine is energized, suppose it is Electricity status, quickly check whether the motor is energized and loaded, because this condition is probably caused by the preform (preform) jamming the advancing belt. At this time, the simple method is to assist the advancing manually. Assuming that the control contactor of the forward machine is not energized, please check whether the preform detection electric eye and the reflector are not in the same straight line.

2. The feeding tray of the old card: This situation is a headache. From the experience, it is assumed that the length of the preform (embroid) of the bottle blowing machine is longer and the cutting weight is larger, then this phenomenon is relatively small of.

　　3. After the bottle is blown, it cannot be taken out of the mold. First of all, you should open the mold, open and close the mold manually, assuming it is normal, and work under the empty working condition, assuming it is also normal. Please check your exhaust time setting. Assuming that the exhaust setting is normal, and if you only need to blow the bottle each time, it is a shortcoming, then it can be judged that the problem is the exhaust valve. Please open the exhaust valve to check the condition of its spring and seal (Another phenomenon of this kind of shortcoming is that the exhaust movement is relatively large or there is a movement of dirty exhaust). Suppose you are encountering a situation where many molds are normally produced and occasionally come to the mold cannot be opened. Please check whether the clamping pin has a segmented screw in it. For others, please check whether the clamping force is too large. If it is too large, please follow The specifications were adjusted from scratch.

　　4. Whether the bottle is always pinched and hurts the position of the manipulator.